Once the slots are located, the next step is to install the computer memory.

If you cannot locate the slots after looking at each of the above recommendations, we recommend you contact the computer manufacturer for additional help and information. On a compartment on the bottom of the laptop.If you are unfamiliar with where these slots are located, below is a listing of possible locations: Notebook (laptop) memory installation stepsīefore the memory can be installed into a notebook, the memory slots must be located. As the memory module is being pushed, the two tabs should snap and hold the memory module into place. When the C-RIMM module is removed, and the two tabs are in the outward position, push the RIMM memory module to a vertical or 90-degree angle. This module is a small circuit board and has only a few or no chips on it. When installing a new RIMM, remove the C-RIMM. This module allows the computer to have a continuous flow of data. What makes RIMM memory modules different from DIMM memory modules is the C-RIMM (continuity RIMM) memory module. How to enter and exit the BIOS or CMOS setup.If you have any difficulties with the memory detected or set up, enter the BIOS setup, and verify the memory is correctly detected by the system. As the computer is booting, the memory should be automatically detected and set up. As the memory module is being pushed, the two tabs should snap and hold the memory module into place.Īfter the memory is installed in the computer, plug the computer back in, and turn it back on. Once these tabs are moved out, gently and firmly push the memory module into the slot. These tabs will snap into place as the memory module is installed. If the memory is incompatible, it will not physically match with the slot.Īfter verifying the notches and direction, the memory needs to be installed, move each memory slot tab out or away from the memory module. These notches allow the memory to be installed only in one direction. Make sure that the notches match up with the memory slot you are installing the memory into.

These notches look like those shown in the picture below. At the bottom of the memory module, you should notice one or more notches at the bottom of the card. When disconnecting anything from the computer, make sure you can remember where each cable and card goes.Įach slot on a motherboard that supports a DIMM (dual in-line memory module) is a bank therefore the computer works if one memory module is purchased.Įxamine the memory module before installing it into the computer. You may have to temporarily remove cables or expansion cards before you can access them easily. If the computer has a small form factor, it may be difficult to access the memory slots.

When inserting ram blue or black slots